ISO TS 6892-5-2025 PDF

ISO TS 6892-5-2025 PDF

Metallic materials-Tensile testing-Part 5: Specification for testing miniaturised test pieces

$48.00 $96.00 -50%
Product Code: ISO TS 6892-5
Stock In Stock
Edition: 1.
Published: 02/2025
Number of Pages: 14
File Size: 1 file, 1 Byte

Available Options

Product Description

Metallic materials — Tensile testing — Part 5: Specification for testing miniaturised test pieces

Introduction: The knowledge of the local strength properties and local flow curves of formed component areas becomes increasingly important for different applications. However, their determination by tensile testing is often restricted because of the possible test piece geometry, the availability of suitable testing equipment and the comparability with the results of the standard tensile tests. By using adjusted test piece geometries, suitable test piece preparation, adapted clamping and extensometer systems and finally an adjusted test procedure tensile test can be performed which gives reproducible and comparable test results. In this document suggestions are given to perform tensile tests on miniaturised test pieces. It describes the state of the art of testing using adjusted standard testing equipment. It is pointed out that the experimental effort (test piece preparation, adjustment and alignment of the testing equipment and also the fine motor skills) is higher than for testing of typical standard test piece geometries. © ISO 2025 – All rights reserved

Scope: This document provides specifications for testing miniaturised metallic test pieces where not enough material is available for test pieces according to ISO 6892-1. The guidelines in this document are not intended to replace the requirements of the standard method described in ISO 6892-1. This document refers to conventionally manufactured materials. NOTE 1 Additional information regarding testing of additively manufactured materials are given in ISO/ASTM 52909[5]. NOTE 2 Further information on the performance of miniaturised test pieces in tensile testing and the comparability of respective results is available in References [8] to [14].

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 6892-5-2025 PDF

ISO TS 6892-5-2025 PDF

$48.00 $96.00