Nanotechnologies — Superhydrophobic surfaces and coatings: Characteristics and performance assessment
Introduction: Surfaces or coatings which are extremely difficult to wet with water can be considered as superhydrophobic. Based on the scientific literature, superhydrophobic surfaces and coatings show contact angles of above 150° as well as contact angle hysteresis less than 10°. Superhydrophobicity phenomena is seen in some natural species, e.g. lotus leaves. Another related term is “lotus effect” which arises for droplets in the Cassie-Baxter wetting state. Various methods have been utilized for the production of superhydrophobic surfaces and coatings, e.g. chemical vapour deposition, spin coating, sputtering, plasma deposition, chemical etching, sol-gel, photolithography, anodizing and plasma electrolyte oxidation. The superhydrophobic surfaces and coatings have numerous applications in different industries due to their properties, which can include self-cleaning, anti-corrosion, anti-icing, anti-fog and antibacterial effects. Such coatings and surfaces are gradually entering automotive, building and construction, healthcare, optical and electrical industries. The market for superhydrophobic surfaces and coatings for 2020 was about $1,8 billion[1]. A common characteristic of superhydrophobic surfaces and coatings is their proper two-level topography (i.e. micro- and nano-sized asperities) combined with low surface energy. This multiscale (hierarchical) roughness would result in large water contact angle, low contact angle hysteresis, and high wetting stability against the Cassie–Baxter
Scope: This document specifies requirements and recommendations for performance assessment methods for superhydrophobic surfaces and coatings subjected to mechanical stress, solar radiation and weathering, liquids, and thermal cycling, where applicable, based on the agreement between interested parties. The performance assessment is carried out based on comparative measurements of the advancing and receding angles and the calculation of the contact angle hysteresis before and after the above-mentioned working/environmental conditions. This document does not address safety and environmental related issues of such coatings. This document is applicable to any superhydrophobic surfaces and coatings (i.e. nanostructured) on which the measurement of the advancing and receding angles is possible.