ISO TS 12512-2017 PDF

ISO TS 12512-2017 PDF

Glass reinforced thermosetting plastic (GRP) pipes - Determination of initial specific ring stiffness using segment test species cut from a pipe

$96.50 $193.00 -50%
Product Code: ISO TS 12512
Stock In Stock
Edition: 1ST
Published: 07/2017
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Glass reinforced thermosetting plastic (GRP) pipes - Determination of initial specific ring stiffness using segment test species cut from a pipe

Introduction: This document develops an alternative to the testing of full pipe rings to measure initial specific ring stiffness (ISO 7685). The goal was to use ring segments which ideally would have led to the use of smaller and more easily handled test specimens and standard testing machines. Much work was done on developing equipment for testing ring segments and on the analysis of loading conditions and calculation procedures and conducting testing programs. There was neither sufficient nor uniform correlation of segment testing results to standard ring testing results to allow the use of segment testing as an alternative stiffness test procedure. There were indications that correlation was perhaps diameter (DN), stiffness class (SN) and pressure class (PN), as well as specimen width, dependent. As initial ring stiffness (SN) is a key classification parameter for GRP pipes this resulted in the segment test being not accepted as a viable alternative stiffness testing procedure. This document presents the last draft of the segment test method. It was agreed to issue this last draft as a Technical Specification so that the work done would not be lost and perhaps will allow interested parties to continue to develop the analysis of loading conditions, equipment development and calculation procedures. It may also prove useful as a research tool. © ISO 2017 – All rights reserved

Scope: This document specifies a method for determining the initial specific ring stiffness of pipes having a nominal size of DN 2000 or larger, using segment test pieces cut from a glass-reinforced thermosetting plastics (GRP) pipe.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 12512-2017 PDF

ISO TS 12512-2017 PDF

$96.50 $193.00