ISO TS 13471-1-2017 PDF

ISO TS 13471-1-2017 PDF

Acoustics - Temperature influence on tyre/road noise measurement - Part 1: Correction for temperature when testing with the CPX method

$71.50 $143.00 -50%
Product Code: ISO TS 13471-1
Stock In Stock
Edition: 1ST
Published: 03/2017
Number of Pages: 22
File Size: 1 file, 424 Bytes

Available Options

Product Description

Acoustics - Temperature influence on tyre/road noise measurement - Part 1: Correction for temperature when testing with the CPX method

Introduction: Air, tyre and road surface temperatures affect noise emission from the tyre/road interaction, as measured by means of, for example, the close-proximity (CPX) method specified in ISO 11819-2. This method allows the user to make measurements within a wide air temperature range (5 °C to 35 °C) which means that temperature influence on the results may be substantial. In the CPX method, one or two reference tyres may be used, as specified in ISO/TS 11819-3; consequently, the temperature corrections need to be valid for these reference tyres. Tyre properties like rubber hysteresis and tread rubber hardness are affected by temperature, but the latter may also affect road surface properties. Temperature effects on noise, therefore, depend on both the tyre and the road surface, the temperatures of which are affected by ambient air temperature. To make it more complicated, the temperature probably has different effects on different noise generation mechanisms. Ideally, and whenever possible, temperature corrections shall be tailored to the tested tyre/road combination. The approach to the temperature correction in this document is semi-generic, which means that under certain conditions a correction to noise for temperature is made common to a group of tyres or a group of road surfaces. This document makes a distinction to the two reference tyres and to a few major road pavement categories. © ISO 2017 – All rights reserved

Scope: This document specifies procedures for determining the effect of temperature on tyre/road noise emission. Temperatures considered are tyre, road and ambient air temperatures. The noise emission for which this document is applicable is measured by means of ISO 11819-2, or similar methods such as the on-board sound intensity (OBSI) method specified in Reference [1]. Measurement results obtained at a certain temperature, which may vary over a wide range, are normalized to a designated reference temperature (20 °C) using a correction procedure specified in this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 13471-1-2017 PDF

ISO TS 13471-1-2017 PDF

$71.50 $143.00