Acoustics — Temperature influence on tyre/road noise measurement — Part 2: Correction for temperature when testing with the pass-by methods
Introduction: Air, tyre and road surface temperatures affect noise emission from the tyre/road interaction, as measured by means of, for example, the statistical pass-by (SPB) method specified in ISO 11819-1 or other pass-by methods. These methods allow the user to make measurements within a wide air temperature range (5 °C to 35 °C) which means that temperature influence on the results may be substantial. Another common type of measurement where temperature effects on tyre/road noise are significant is for noise tests on tyres most commonly conducted as pass-by on test tracks with a reference surface according to ISO 10844[1]. This case is also considered in this document, with the aim to reduce the uncertainties in such measurements. These are often made for legal purposes, such as type approval or labelling of tyres or vehicles where tyres are the dominant noise source. This is further dealt with in Annex A. Temperature effects on noise depend on both the tyre and the road surface, the temperatures of which are affected by ambient air temperature. The temperature has different effects on different noise generation mechanisms and when also considering the effect of possible power unit noise mixed with tyre/road noise, the temperature effect becomes even more complicated. Ideally, and whenever possible, temperature corrections shall be tailored to not only the tested tyre/road combination as well as to different tyre and vehicle categories, but also to the type of measurement method. For
Scope: This document specifies correction procedures for the effect of temperature on vehicle noise emission, as influenced by the tyre/road noise contribution. Temperatures considered are road and ambient air temperatures. The noise emission for which this document is applicable is measured by means of ISO 11819-1, or similar methods such as the American methods SIP and CTIM specified in References [3][4]. It is also applicable to other pass-by measurements conducted without acceleration, such as when testing tyres and vehicles on test tracks with ISO 10844[1] reference surfaces; however, given that tyre/road noise is dominant. Measurement results obtained at a certain temperature, which may vary over a wide range, are normalized to a designated reference temperature (20 °C) using a correction procedure specified in this document.