ISO TS 14778-2021 PDF

ISO TS 14778-2021 PDF

Paper and board-Measurement of water contact angle by optical methods

$48.00 $96.00 -50%
Product Code: ISO TS 14778
Stock In Stock
Edition: 1ST
Published: 01/2021
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Paper and board — Measurement of water contact angle by optical methods

Introduction: The interaction between the liquid and the solid phases influences the contact angle. Contact angles above 90° define a situation where the liquid is repelled by the solid; below 90° defines a situation of attraction where the liquid wets the surface. The magnitude above or below 90° shows the relative degree of repulsion or attraction between the two phases. On many surfaces the contact angle varies with duration of contact through a combination of spreading, penetration (in the case of porous substrates) and evaporation. Both manual and automated apparatus are available for optical measurement of contact angle, but automated equipment is preferred for precision and rapid measurement, and because it is often applicable to a wider combination of liquid and paper or board samples. Contact angle measurement is used to predict how liquids interact with paper surfaces. This document describes the most common form of test, using water as probe liquid, and from the data a probable interaction between the paper surface and another liquid with comparable surface tension and viscosity characteristics is often inferred. The veracity of this inference should be tested wherever possible. Notwithstanding the above, contact angle measurement is used widely as a predictive tool in several industrial settings, for example: a) for assessing writing, ruling or printing quality with water-based or solvent based inks (e.g. in inkjet, gravure or flexographic printing); b) for gluing applications;

Scope: This document specifies the method for optical assessment of the contact angle between water and the surface of paper and board, where the process of droplet formation, application to planar substrates, or measurement of the droplet shape in contact with the solid is performed by automated equipment. The limits of measurement are determined by the capabilities of the instrumentation used. The instrumental capabilities defined by this document use a digital image capturing system operating at a minimum of 50 frames per second and needs the ability to perform the first measurement after no more than 20 ms to 40 ms contact between the droplet and substrate. The test method is applicable to most kinds of paper or board however it cannot be applicable to structured materials.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 14778-2021 PDF

ISO TS 14778-2021 PDF

$48.00 $96.00