Test methods for repair materials for water-leakage cracks in underground concrete structures — Part 2: Test method for chemical resistance
Introduction: This document is linked to ISO/TR 16475. ISO/TR 16475 outlines six basic properties and the required performance levels of water leakage repair materials, and the ISO/TS 16774 series proposes sample testing methods that are capable of evaluating the respective properties of the repair materials. The test methods in this document are intended to serve as a reference for nations that have not yet developed a test method on the six required performance properties of water leakage repair materials. If other forms of test methods that are simpler, more accurate or more organized are available, such methods are recommended for use instead. Many of the dependent variables outlined in the reference test methods of this document are subject to change in accordance with the environmental conditions (temperature and humidity, chemical solution and concentration, width of movement activity, water pressure or water flow velocity, etc.) outlined in the standards used in respective countries. For ISO/TS 16774-1, ISO/TS 16774-5 and ISO/TS 16774-6, for the purpose of objectively comparing the performance of injected repair materials, artificial cracks of same width, height, and volume were used to control the usage of repair materials for each testing cycle and enable repetition of the same test methods under the same conditions. © ISO 2023 – All rights reserved
Scope: This document specifies a laboratory test method for the qualitative determination of the retention level of chemical resistance of repair materials in repaired cracks of concrete structures in conditions where the material is either underwater or in contact with water that can have various chemical components present.