Gas cylinders - Refillable permanently mounted composite tubes for transportation
Introduction: This document provides a specification for the design, manufacture and initial inspection and testing of composite tubes permanently mounted in a transport frame for worldwide usage. Current standards, such as ISO 11515 and ISO 11119, do not address the interaction between the tubes and the transport frame. This document aims to eliminate existing concerns about duplicate inspection and restrictions because of the lack of International Standards and should not be construed as reflecting on the suitability of the practice of any nation or region. This document has been written so that it is suitable to be referenced in the UN Model Regulations[6]. This document addresses tubes of larger volume than previous documents. This document is not applicable to on-board fuel cylinders in natural gas vehicles. Annexes B to F are informative. Annex A is normative. vi © ISO 2019 – All rights reserved
Scope: This document specifies the minimum requirements for the material, design construction and workmanship, manufacturing processes, examination and testing at time of manufacture of an assembly of permanently mounted composite tube(s) in a frame with associated components. Tubes covered by the requirements of this document are: a) of composite construction, permanently mounted in a transport frame and suitable for specified service conditions, designated as: 1) Type 3 — a fully wrapped tube with a seamless metallic liner and composite reinforcement on both the cylindrical part and the dome ends; or 2) Type 4 — a fully wrapped tube with a non-load sharing liner and composite reinforcement on both the cylindrical part and the dome ends. b) with water capacities from 450 l up to and including 10 000 l; c) containing compressed gases but excluding: 1) liquefied gases, 2) dissolved gases, and 3) gases and gas mixtures which are classified for transport as toxic or oxidizing; d) with working pressure up to 1 000 bar. This document does not address tubes with working pressure times water capacity (p × V) more than 3 000 000 bar∙l.