ISO TS 17902-2016 PDF

ISO TS 17902-2016 PDF

Wrapped electrofoaming joints for polyethylene (PE) piping systems with smooth outer wall for gravity drains and sewers

$71.50 $143.00 -50%
Product Code: ISO TS 17902
Stock In Stock
Edition: 1ST
Published: 11/15/2016
Number of Pages: 20
File Size: 1 file, 583 Bytes

Available Options

Product Description

Wrapped electrofoaming joints for polyethylene (PE) piping systems with smooth outer wall for gravity drains and sewers

Introduction: This document is the specification for electrofoaming plastic pipe joints used in non-pressure underground drainage and sewerage for polyethylene (PE) piping systems with smooth outer wall. The wrapped electrofoaming joints may also be applied to pipes with diametrically deviated pipe ends. The installation procedures specified in this document are intended to describe the proper joining method of electrofoaming joints. An informative guidance for the joining procedure of products complying with this document is provided in Annex A. © ISO 2016 – All rights reserved

Scope: This document specifies the definitions and requirements for wrapped electrofoaming joints for polyethylene (PE) piping systems with smooth outer wall for underground drains and sewer without pressure. This document specifies product range, material characteristics, test methods and test parameters, dimension and characteristics of wrap. This document is applicable to jointing pipes which have external wall thickness greater than 1,4 mm and a diameter up to DN/OD 2000, or DN/ID 2200. NOTE 1 For dimensions larger than DN/OD 2000, or DN/ID 2200, this document can serve as a general guide regarding appearance, colour, physical and mechanical characteristics as well as performance requirements. NOTE 2 Such products are intended to be used with pipes made from virgin and reworked materials.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 17902-2016 PDF

ISO TS 17902-2016 PDF

$71.50 $143.00