Imaging materials — Photographic prints — Effect of light sources on degradation under museum conditions
Introduction: One of the typical uses of prints in museums is their display in a permanent or temporary exhibition under ambient light or artificial illumination. In general, prints may fade due to various environmental stresses, such as light, heat, humidity, pollutants, or biological attack, and the combination of these factors. A museum can fully or partially control and suppress most of those factors. However, light is necessary for display and will cause some degradation over time[1]. This document will provide guidance on how to assess light exposure-related damage to analogue and digital photographic prints under museum display conditions for particular print materials sets. The choice of the light source with the lowest damage potential depends on the specific material types in the mix and the spectral irradiance of the light source. The document can be of benefit to curators, conservators and lighting designers to select the display lighting with the lowest possible damage potential to an exhibition. It can serve the manufacturers for lighting materials to develop particular solutions for the museum. Depending on the use case, material type and conditions, a two-tier evaluation may be possible. Tier I evaluation is useful for comparison of different light sources, namely, to identify the light source that will result in smallest image fading (∆E) under a given exposure level (lx-h). Tier II evaluation is useful to estimate appropriate illumination levels (lx) to reach intended dis
Scope: The test method in this document is intended to be used to characterize and compare the degradation of a set of print materials under exposure to particular light sources, eventually including optical filter combinations, under museum environmental conditions. The document covers typical types of indoor light sources commonly found in a museum including indoor daylight, LED, and incandescent light. This document is applicable to analogue and digital reflection photographic prints. NOTE Examples of photographic prints covered by this document are prints made with digital printing technologies such as inkjet, electrophotography, and thermal dye transfer, as well as prints made on silver halide colour paper but not prints made on black and white silver halide paper.