ISO TS 19022-2016 PDF

ISO TS 19022-2016 PDF

Plastics - Method of controlled acceleration of laboratory weathering by increased irradiance

$48.00 $96.00 -50%
Product Code: ISO TS 19022
Stock In Stock
Edition: 1ST
Published: 02/01/2016
Number of Pages: 18
File Size: 1 file, 293 Bytes

Available Options

Product Description

Plastics - Method of controlled acceleration of laboratory weathering by increased irradiance

Introduction: A realization of the acceleration of laboratory weathering under controlled conditions is an essential requirement for delivering reliable and fast prediction of material durability. In this connection, the correlation to real use aging behaviour is being checked constantly. The fundamental parameters of a weathering test are simulated solar radiation, heat and moisture. The induced change in the material properties, among other things, is determined by the irradiance level and relative spectral irradiance of simulated solar radiation incident on the material surface during the test, the surface temperature, and the level of moisture. An increase in some well-known weather parameters, continuously monitored outdoors, offers opportunities to speed up the weathering process outdoors and in the laboratory. Since 1967, acceleration of outdoor weathering with instruments for intensified weathering using concentrated solar radiation (according to ISO 877-3) became a common practice. By concentrating the natural solar radiation with Fresnel mirrors, irradiances of five to six times higher than the maximum natural level has been reached. Already in 1996, a screening procedure with very high irradiances for dyed textiles were developed which enabled the reduction of the test duration for lightfastness grades from five days to seven days to two and a half days.[5] However, the applicability of an increased irradiance for deterministic acceleration of weathering without a specific knowl

Scope: This Technical Specification specifies a test method which allows predicting the aging rate of material specimens, e.g. plastics, under interest independent of the aging mechanisms as a function of radiant exposure. The UV irradiance of a simulated solar radiation (with a laboratory radiation source) will be extended above the normal maximum level on earth surface while keeping all relevant temperature parameters fixed. NOTE For translucent plastics, the surface temperatures are below the white standard temperature. In addition, the maximum temperature is not on the irradiated surface, it is somewhere inside the plastic material.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 19022-2016 PDF

ISO TS 19022-2016 PDF

$48.00 $96.00