Plastics — Instrumented micro-indentation test for hardness measurement
Introduction: This document was developed in response to a demand to define an instrumented indentation hardness test method in the micro scale for quality control of plastics materials and material selection. The test conditions are defined to ensure reproducibility and comparability of test results. The Rockwell hardness method (ISO 2039-2) and the ball indentation method (ISO 2039-1) have been formulated for determining the indentation hardness of plastics. These test methods use different scales depending on the hardness of the material and it is difficult to compare hardness values of materials when they are measured on different scales. The Vickers hardness test method (ISO 6507-1), used for metallic materials, is a method that does not use different scales. The Vickers hardness is calculated as the ratio of indentation load and the residual area of contact of the indenter. However, when this method is applied to plastics materials, it is difficult to measure the residual area of contact of the indenter because the edge of the indentation cannot be specified. The instrumented indentation hardness test method (ISO 14577-1) is intended for hardness measurement in the range from nano-indentation to macro-indentation. In this method, since the contact area of the indenter is directly determined from the indentation depth, the above-mentioned problem is solved. It is therefore possible to determine the indentation hardness of the plastic materials. In this document, in order to avoid erro
Scope: This document specifies a hardness test method for plastics using instrumented indentation in the micro scale with one clearly defined test condition to ensure reproducibility and comparability of test results. The test method is selectively suitable for use with the following materials: — moulding, extrusion and cast thermoplastic materials; rigid and semi-rigid thermoplastics sheets; — rigid and semi-rigid thermosetting moulding materials; thermosetting sheets. This test method could also be utilized for nanometric filled system, considering the fillers are distributed uniformly in the polymer matrix. This test method allows dumbbell type specimen, strip type specimen, platens and specimen cut from any finished parts or products. This test method is useful for quality control, material selection, and screening of new formulations. NOTE This document does not aim to describe all scientific or technical aspects of microhardness testing on plastics in general.