ISO TS 19392-5-2023 PDF

ISO TS 19392-5-2023 PDF

Paints and varnishes-Coating systems for wind-turbine rotor blades-Part 5: Measurement of transmittance properties of UV protective coatings

$48.00 $96.00 -50%
Product Code: ISO TS 19392-5
Stock In Stock
Edition: 1.
Published: 03/2023
Number of Pages: 18
File Size: 1 file, 1 Byte

Available Options

Product Description

Paints and varnishes — Coating systems for wind-turbine rotor blades — Part 5: Measurement of transmittance properties of UV protective coatings

Introduction: In the wind energy industry, coatings are applied to rotor blades surface to protect the glass fibre reinforced polymer composite substrate from environmental stresses. Rain drops and hailstones can damage these coatings in such a way that individual layers come off or the whole coating delaminates from the substrate. This applies mostly to the leading edge. Glass fibre reinforced polymer composites and other blade materials can be also sensitive to UV degradation and thus can be damaged during outdoor operation, if not protected accurately against irradiation by solar radiation. Failure of protection can lead to delamination and a subsequent failure of the full blade. An important function of the rotor blade coating is therefore to protect the blade material from UV radiation. This applies to the leading edge, but also to the other surface areas of the blade. The damage by solar radiation is mainly induced by the most energetic ultraviolet (UV) radiation, but also visible (VIS) radiation (e.g. violet or blue radiation) is still energetic enough to have a negative input on the appearance and durability of the blade. Pigments and organic or inorganic UV absorbers can be used to reduce the coating film transmittance against UV (and visible) radiation and cause a positive effect on lifetime and functional aspects of the blade material. Pigments and UV absorbers can affect the transmittance in the visible range. This may lead to colour change of the coated blade. This document, a

Scope: This document specifies a test method to measure the ultraviolet (UV) and visible (VIS) spectral transmittance in the wavelength range from 280 nm to 700 nm of coatings for wind turbine rotor blades. Single and multilayer coatings or coating systems can be tested. From the spectral transmittance the transmittance of UV, VIS and the combined UV and VIS wavelength range can be calculated. It is applicable to free coatings films or coatings applied on a UV-transparent quartz substrate.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 19392-5-2023 PDF

ISO TS 19392-5-2023 PDF

$48.00 $96.00