ISO TS 20273-2017 PDF

ISO TS 20273-2017 PDF

Guidelines on weld quality in relationship to fatigue strength

$129.00 $258.00 -50%
Product Code: ISO TS 20273
Stock In Stock
Edition: 1ST
Published: 08/2017
Number of Pages: 52
File Size: 1 file, 3 Bytes

Available Options

Product Description

Guidelines on weld quality in relationship to fatigue strength

Introduction: This document has been derived from the main results given in Reference [28] which was previously published as XIII-2510-13. It constitutes the considered judgment of experts on fatigue in welded joints assuming thicker plates in steel. For further or more detailed information, see Reference [28]. This document is applicable where fatigue assessment is assumed to be based on either the nominal stress approach or structural stress approach as defined by References [1] and [2]. More refined fatigue assessment methods based on notch stress concepts or fracture mechanics already included the ability to completely or partially account for weld geometric features and imperfections and are not specifically covered by this document. It is assumed that the user has a working knowledge of the basics of fatigue and fracture mechanics. In some cases, working knowledge of finite element analysis is also needed. The recommendations and guidelines are considered to reflect the fatigue strength of the welded joint itself with a defined survival probability but without environmental effects. They are thus applicable to many industrial sectors. It is assumed that the user will apply good principals of limit state structural design. Appropriate partial safety factors for load and resistance are to be applied depending on the industry. This document does not define the partial safety factors for load or resistance to be used in fatigue assessment. © ISO 2017 – All rights reserved

Scope: This document provides guidance for setting appropriate weld quality requirements in relation to fatigue. This document is applicable to fusion (arc and/or beam welding) welded steel plate-type structures having a thickness of >3 mm, which are subjected to cyclic loading. Due to lack of experimental data for aluminium welds and ultra-high strength steels, the fatigue strength (or S-N) curves apply only to structural steel up to a maximum specified yield strength of 960 MPa. The acceptance criteria in this document may be applied to higher strength steels, stainless steels and certain concepts to 5000 and 6000 series of aluminium alloys which are commonly used in welded structures. In the absence of relevant published data, it is recommended that this be quantified by special testing.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 20273-2017 PDF

ISO TS 20273-2017 PDF

$129.00 $258.00