ISO TS 20459-2023 PDF

ISO TS 20459-2023 PDF

Road vehicles-Injury risk functions for advanced pedestrian legform impactor (aPLI)

$162.00 $324.00 -50%
Product Code: ISO TS 20459
Stock In Stock
Edition: 1.
Published: 04/2023
Number of Pages: 164
File Size: 1 file, 23 Bytes

Available Options

Product Description

Road vehicles — Injury risk functions for advanced pedestrian legform impactor (aPLI)

Introduction: This document has been prepared on the basis of the existing injury probability functions (IPFs) to be used with the advanced pedestrian legform impactor (aPLI) standard build level B (SBL-B). The purpose of this document is to document the IPFs for the aPLI in a form suitable and intended for worldwide harmonized use. In 2014, development of the aPLI hardware and associated IPFs started, with the aim of defining a globally accepted next-generation pedestrian legform impactor with enhanced biofidelity and injury assessment capability, along with its IPFs, suitable for harmonized use. Participating in the development were research institutes, dummy and instrumentation manufacturers, governments, and car manufacturers from around the world. IPFs for the aPLI specified in this document predict injury probability to specific regions of the lower limb of a pedestrian that corresponds to maximum values of injury metrics obtained by the aPLI in a subsystem test, as described in References [1] and [2]. As the IPFs do not provide any threshold values, users will need to determine target injury probability, based on their specific needs, to define injury assessment reference values to be used for their test protocol. It is also important to note that the subsystem test procedure (STP) for pedestrian protection may not be representative of pedestrian accidents for specific injury metrics, depending on their sensitivity to pedestrian impact conditions such as lower-limb posture and muscl

Scope: This document provides definitions, symbols and injury probability functions (IPFs) for the thigh, leg and knee intended to be used with the advanced pedestrian legform impactor (aPLI), a standardized pedestrian legform impactor with an upper mass for pedestrian subsystem testing of road vehicles. They are applicable to impact tests using the aPLI at 11,1 m/s involving: — vehicles of category M1, except vehicles with a maximum mass above 2 500 kg and which are derived from N1 category vehicles and where the driver’s position, the R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by a maximum of 1 100 mm; — vehicles of category N1, except where the driver’s position, the R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by maximum of 1 100 mm; — impacts to the bumper test area defined by References [1] and [2]; — pedestrian subsystem tests involving use of a legform for the purpose of evaluating compliance with vehicle safety standards.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 20459-2023 PDF

ISO TS 20459-2023 PDF

$162.00 $324.00