Photography — Photographic reflection prints — Part 2: Evaluation of colour variation in printing
Introduction: In photographic reflection colour prints, density and colour are essential quality attributes of an image. However, the density and colour of prints can fluctuate during repeated continuous printing or vary between two printings done at different times or days, even if the same input data and printer settings are used. This is a critical issue, particularly in the following cases: a) When the same photographic image is reprinted to make an extra copy and there is obvious difference in density and colour between the original and the reprint when they are compared side by side, the customer might be dissatisfied with this difference. b) When a photo book is produced by binding up photographic prints into different pages in a book, and the difference in the density and colour between adjacent pages is easily noticeable, this difference might be considered unsatisfactory by the customer. c) When a customer and a print shop agree to the image quality of prints based on a sample or a proof print, and the difference between the proof sample and the actual prints is discernible, this might lead to customer dissatisfaction. Moreover, colour management for high quality printing is attainable only with a stable printing system. If the colour and density of the actual print differ from that of the designated proof print or sample used as the basis for the colour management, the quality of the actual print may be different from the desired image quality. To improve the reproducibility of
Scope: This document describes the procedures for evaluation of colour variation in the printing of photographic reflection colour prints. The following procedures are described to evaluate colour variation in printing within a consecutive print job, between several print jobs, or between multiple photographic images printed in different areas of a large sheet: a) test targets for small and large photographic prints; b) printing procedures and conditions; c) sampling in correspondence to the production scale; d) measurement of colour; e) calculation and analysis of colour variation and f) reporting. The procedures presented in this document are applicable for prints with a size of available picture area ranging from 35 cm2 (e.g. 5 cm × 7 cm) to 5 400 cm2 (e.g. 60 cm × 90 cm). This document is applicable to any of the photographic printing technologies, including inkjet, thermal dye transfer, electrophotography and silver halide (chromogenic) technologies.