Multilayer piping systems for hot and cold water installations inside buildings - Part 7: Guidance for the assessment of conformity
Introduction: This document can be used to support elaboration of national third party certification procedures for products conforming to the applicable part(s) of ISO 21003. This document is a part of a System Standard for plastics piping systems of a particular material for a specified application. There are a number of such System Standards. At the date of publication of this document, System Standards for piping systems of other plastics materials used for the same application are the following: — ISO 15874, Plastics piping systems for hot and cold water installations — Polypropylene (PP) — ISO 15875, Plastics piping systems for hot and cold water installations — Crosslinked polyethylene (PE-X) — ISO 15876, Plastics piping systems for hot and cold water installations — Polybutene (PB) — ISO 15877, Plastics piping systems for hot and cold water installations — Chlorinated poly (vinyl chloride) (PVC-C) — ISO 22391, Plastics piping systems for hot and cold water installations — Polyethylene of raised temperature resistance (PE-RT) They are supported by separate standards on test methods to which references are made throughout the System Standard. The System Standards are consistent with general standards on functional requirements and on recommended practice for installation. Figures 1 and 2 are intended to provide general information on the concept of testing and organisation of those tests used for the purpose of the assessment of conformity. For each type of test, i.e. type testing (T
Scope: This document gives requirements and guidance for the assessment of conformity of compounds, products, and assemblies in accordance with the applicable part(s) of ISO 21003 intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of certification procedures. In conjunction with the other parts of ISO 21003 (see Foreword), this document is applicable to multilayer piping systems intended to be used for hot and cold water installations within buildings for the conveyance of water, whether or not intended for human consumption (domestic systems) and for heating systems, under design pressures and temperatures appropriate to the class of application (see ISO 21003-1:2008, Table 1).