Nanotechnologies — Method to quantify air concentrations of carbon black and amorphous silica in the nanoparticle size range in a mixed dust manufacturing environment
Introduction: Nanomaterials are widely used in industrial settings in the manufacture of consumer products. Carbon black and amorphous silica are commonly used in consumer products, such as rubber products, insulating materials, and others. Although these materials typically exist as agglomerates in dimensions larger than the nanoscale, there is also the potential for worker exposure to these materials in the nanoscale size range. In spite of the widespread use of nanomaterials such as these, quantification of air concentrations of specific nanomaterials in mixed dust settings, such as a manufacturing environment, has been challenging to date and has been identified as a hindrance to the development of nano‐specific occupational exposure limits (see References [3], [4] and [6]). This method outlines a technique whereby particles of carbon black and amorphous silica can be identified, distinguished, and quantified (in terms of air concentrations) by size in such manufacturing settings. It is anticipated that although this method is specific to carbon black and amorphous silica, the general principles of the method can be applied to many materials in a variety of manufacturing environments. This method advances beyond existing techniques for analysis in that it provides quantitative information regarding exposure to specific materials by size; many other methods provide quantitative information on nanoparticle exposures that are incapable of differentiating by material type. This method incl
Scope: This document specifies a method to quantify and identify air concentration (number of particles/cm3) of particles of either carbon black or amorphous silica, or both, by size in air samples collected in a mixed dust, industrial, manufacturing environment. This method is applicable to air samples collected with an electrical low pressure cascade impactor (ELPCI) for sampling in manufacturing environments where there are a variety of particle types contributing to the overall atmosphere. This method is applicable only to environments with chemically and physically distinct particles contributing to aerosols or where confounders can be controlled (e.g. diesel sources).