ISO TS 21913-2022 PDF

ISO TS 21913-2022 PDF

Temperature verification method applied to dynamic fatigue testing

$71.50 $143.00 -50%
Product Code: ISO TS 21913
Stock In Stock
Edition: 1ST
Published: 06/2022
Number of Pages: 20
File Size: 1 file, 884 Bytes

Available Options

Product Description

Temperature verification method applied to dynamic fatigue testing

Introduction: It is the aim of this document to provide methodologies to verify the error in indicated measurement relative to the actual temperature of the specimen test piece. Therefore, it is essential to account for all factors, inclusive of environmental effects; not limiting the assessment to, for example, the performance of a recording system and the thermoelectric coefficient of a batch of thermocouple wire. Certain types of test and advanced simulation rely on accurately controlled and rapidly changing temperature during the test, usually synchronised with control of mechanical loading. Within the scope of this document, that would usually be a thermo-mechanical fatigue test. Where temperature varies deliberately and rapidly during the test, it is appropriate to verify the degree of time lag in system temperature reading. Without this evaluation (and implicitly a correction) then either the apparent temperature accuracy or the phase accuracy may need to be unnecessarily reduced. This document has been written with the intention of using congruent language and approach to that used for calibration of extensometers[1] and verification of force measurement[2][3]. © ISO 2022 – All rights reserved

Scope: This document establishes verification procedures to determine the accuracy, speed of response, and stability of temperature measurement for materials testing equipment. These procedures are specified for the expected use in fatigue tests on metals where these characteristics are important to the fidelity of tests at high or varying temperature. The principles set out include sufficient provision for both contacting and non-contacting methods of temperature measurement. This document is for the end-to-end verification of registered value compared with “true” specimen temperature at the point of measurement. It cannot be used to specify the correct method or location of measurement. NOTE The methodologies could be found applicable to test types beyond mechanical fatigue of metals, but that is outside the remit of this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 21913-2022 PDF

ISO TS 21913-2022 PDF

$71.50 $143.00