Ultrasonic testing of hardmetals
Introduction: Ultrasonic testing of hardmetals is a method used for judging the nature of internal defects. It is based on the reflection characteristics of similar waveforms by comparison with the reflection waveforms of standard test blocks with internal defects. It describes how to use high-frequency sound waves to detect micron-sized defects such as carbon defect, eta-phase, tungsten carbide (WC) aggregates, under-sintered area, cobalt pool, and other structural defects. The equivalent size of hole was determined by distance amplitude defect (DAC), and the indicating length of crack was determined by judging the boundary of defect. This document covers requirements for personnel qualification, surface requirements of the tested products, environment and coupling agent during ultrasonic testing of hardmetals. This document also covers the requirements for ultrasonic testing equipment performance, materials of test block, tolerance of internal flat bottom hole, sensitivity design and defect identification. © ISO 2026 – All rights reserved
Scope: This document specifies an A-type ultrasonic pulse contact method applying the ultrasonic longitudinal wave technique to hardmetals. This document is applicable to the ultrasonic inspection for a hardmetal rod that has a circular end face with a diameter not less than 6,0 mm and a rod length of 40,0 mm to 380,0 mm, or a hardmetal product that has a non-circular testing area not smaller than the coverage area of the probe (not less than 12,0 mm in diameter) and a height of 10,0 mm to 380,0 mm. Within the detection range specified in this document, the sound transmission energy is expressed by the probe driving voltage, and the range is 100,0 V to 200,0 V.