Sports and recreational facilities — Impact surfacing testing device
Introduction: Impact attenuating surfacing has been shown to be fundamental to the prevention of 60 % to 75 % of the injuries in playgrounds from impacts with the surface after a fall. The surface materials can be sourced and installed locally such as sand, wood chips or rounded gravel, while others could be sourced from materials around the world and assembled on site such as poured in place rubber, tiles, mats or synthetic turfs and installed at local playgrounds. The performance of installed surfacing materials should be comparable from playground to playground no matter where this playground is situated. The equipment used to measure the performance of playground surfacing is internationally consistent, repeatable and reproducible. The field of impact attenuation measurement as it applies to playground safety surfaces is very small, resulting in a limited market for potential manufacturers of such equipment. While a small number of reputable manufacturers do exist, organizations needing playground impact test equipment, such as test laboratories and university researchers, often have to rely on their own technical abilities or those of related engineering departments to create the needed equipment from scratch. A wealth of information is available to aid in the effort to build one’s own instruments. Of particular note is ISO 6487, which details impact measurement particularly of anthropomorphic test dummies in automotive environments. But as ISO 6487 deals with automotive situations, s
Scope: This document gives the specifications for impact attenuation testing equipment used to evaluate the impact performance characteristics of playground surfacing. Its specifications are aimed at ensuring that developers and manufacturers of such instruments meet minimum performance characteristics to allow repeatable, reproducible and accurate results. This document does not specify a test method. NOTE Such test methods are covered in other standards, e.g. EN 1177, ASTM F1292, ASTM F3313, AS 4422, CSA Z614.