Cigarettes - Determination of loss of tobacco from the ends - Part 3: Method using a vibro-bench
Introduction: The loss of tobacco from cigarette ends, which particularly affects short strands, is a nuisance for the industry, as well as for the consumer. From this standpoint, the greater a cigarette’s resistance to loss from its end, the higher its quality. The devices available for measuring such loss of tobacco are based on the principle of mechanically vibrating cigarettes in a cigarette-containing tester. ISO 3550–1 and ISO 3550–2 describe two particular types of device. The first, described in ISO 3550-1, comprises a rotating cylindrical cage through which tobacco is allowed to fall into a weighing vessel. The second, described in ISO 3550-2, uses a cubic box rotating around its main diagonal axis. A third method, based on use of a vibro-bench, vibrating along the horizontal direction is described in this part of ISO 3550. The first system (ISO 3550-1) principally permits determination of losses undergone by the cigarette during the manufacturing and packaging processes, while the second method (ISO 3550-2) can be used to estimate tobacco losses undergone throughout the distribution network and in the smoker’s pocket. The third method (ISO/TS 3550-3) is applicable to the determination of tobacco losses that the cigarette is likely to undergo throughout its lifecycle. The three methods were designed for different application fields by using different simulation test devices with completely distinct mechanical structures, so the physical meanings of results given with three methods
Scope: This part of ISO 3550, as Technical Specification, specifies a method for the determination of loss of tobacco from cigarette ends using a vibro-bench. This method applies to the determination of loss of tobacco from cigarette ends in manufacturing site, throughout the distribution network and also while in the smoker’s pocket. NOTE Two other methods for the determination of loss of tobacco from the ends, using a rotating cylindrical cage and a cubic rotating box (sismelatophore), are described in ISO 3550-1 and ISO 3550-2, respectively.