ISO TS 4210-10-2020 PDF

ISO TS 4210-10-2020 PDF

Cycles-Safety requirements for bicycles-Part 10: Safety requirements for electrically power assisted cycles (EPACs)

$162.00 $324.00 -50%
Product Code: ISO TS 4210-10
Stock In Stock
Edition: 1ST
Published: 07/2020
Number of Pages: 132
File Size: 1 file, 4 Bytes

Available Options

Product Description

Cycles — Safety requirements for bicycles — Part 10: Safety requirements for electrically power assisted cycles (EPACs)

Introduction: This document combines several countries’ safety requirements for Electrically Power Assisted Cycles (EPACs). The commercialization of EPACs has accelerated in the global market, in response to global concerns about CO2 reduction and energy saving. EPAC technologies for performance, electrical control, battery management and battery charging are currently developing rapidly in a competitive market. It is therefore necessary to standardize the safety of these technologies for EPACs. This documentation will allow an easy and clear understanding of requirements for different types of EPAC. This document includes safety requirements for the charging of EPACs. This includes off-board parts and EPAC battery chargers. This document does not state the limit for the maximum permissible load of the EPAC. The manufacturer is advised to consider amongst other factors the maximum permissible load (luggage plus rider) as well as the intended use of the EPAC. Both have an influence on the mechanical requirements. vi © ISO 2020 – All rights reserved

Scope: This document specifies safety and performance requirements for the design, marking, assembly, and testing of two wheeled electrically power assisted cycles (hereafter EPACs), fully-assembled EPACs and subassemblies, and provides guidelines for information supplied by the manufacturers (i.e. instructions on the use and care of such EPACs). This document applies to two wheeled EPACs that have a maximum saddle height of 635 mm or more and are intended for private and commercial use with exception of EPACs intended for hire from unattended stations. This document is intended to cover all common significant hazards, hazardous situations and events listed in 5.3 of EPACs, when used as intended or under conditions of misuse that are reasonably foreseeable by the manufacturer. This document specifies requirements and test methods for engine power management systems, electrical circuits including the charger for the assessment of the design and assembly of EPACs and sub-assemblies for systems having a Safety Extra Low Voltage (SELV) maximum voltage up to 60 V d.c. including tolerances.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 4210-10-2020 PDF

ISO TS 4210-10-2020 PDF

$162.00 $324.00