Fire detection and alarm systems — Part 30: Design, installation, commissioning and service of video fire detector systems
Introduction: The installation of a video fire detection system (VFDS) can only be successfully accomplished if the following conditions are fulfilled: — materials are of a suitable quality; — special knowledge in the field of video fire detection (VFD) is implemented; — skilled personnel carry out the work. Although the quality of the material can be ensured by adherence to applicable standards and quality audits, the overall effectiveness of an installation depends widely on the quality of work, the experience of the designer and installer, and regular service. This document has been prepared by ISO/TC 21/SC 3. A number of existing national codes and standards were reviewed during the preparation of this document. As VFD technology is significantly different from conventional fire detection technology, different considerations need to be addressed and therefore a document specifying the installation of VFDSs has been developed. While specific to VFDSs, this document has the same objective of early fire detection as ISO 7240-7. This document specifies the minimum requirements for fire detection installation using equipment conforming ISO/TS 7240-29. © ISO 2022 – All rights reserved
Scope: This document specifies the design, installation, commissioning and service requirements for video fire detector systems (VFDS; see ISO/TS 7240-29), which are primarily intended to provide early detection of fire within one or more specified indoor areas for the protection of lives and equipment. The VFDS can also serve to protect from specific defined risks. The VFDS can be an independent fire detection system or can be used in conjunction with a fire detection and alarm system (FDAS; see ISO 7240-1:2014, Figure 1).