W/D S/S BY UL 1203 These requirements cover switches for installation and use in hazardous (classified) locations Class I, Division 1, Groups A, B, C, and D, and Class II, Division 1, Groups E, F, and G, in accordance with the National Electrical Code, NFPA 70. These requirements also cover explosion-proof electrical equipment for installation and use in Class I, Zone 1, Groups IIA, IIB, IIB plus Hydrogen, and IIC hazardous (classified) locations. These requirements cover snap and similar switches rated 60 amperes or less at 250 volts or less; 30 amperes or less at 600 volts or less; and 2 horsepower or less at 600 volts or less. These requirements do not cover knife, enclosed, clock-operated, or magnetically-operated switches, or industrial control equipment such as auxiliary devices and magnetic or manual motor controllers. These requirements apply to switches for hazardous locations under the following atmospheric conditions: An ambient temperature between minus 25°C (minus 13°F) and plus 40°C (plus 104°F). An oxygen concentration of not greater than 21 percent by volume, and A nominal barometric pressure of one atmosphere. A product that contains features, characteristics, components, materials, or systems new or different from those covered by the requirements in this standard, and that involves a risk of fire, electric shock, or injury to persons shall be evaluated using the appropriate additional component and end-product requirements as determined necessary to maintain the acceptable level of safety as originally anticipated by the intent of this standard. A product whose features, characteristics, components, materials, or systems conflict with specific requirements or provisions of this standard cannot be judged to comply with this standard. Where considered appropriate, revision of requirements shall be proposed and adopted in conformance with the methods employed for development, revision, and implementation of this standard.